Forkliftaction.com

DISCUSSION FORUMS : Forkliftaction.communicate

My forum profile

Printable version

Discussion Forums Home

Forum:

Technical arena

Discussion:

Caterpillar EP25K 2001 80volt with drive and pumpcontroller

Number of messages: 6

START MESSAGE:

blackie
Gelderland, Netherlands

Hello

Whe have a foultcode 67.
I know 1 off the 2 prints is not good. (But witch one?)

Whe know you need software to get in the controller.
Is there somebody who can help us whith codes and/or software?

Cheers

-------------------------
prajfa@hotmail.com

Posted 2 Dec 2008 09:50 PM

Report this message

REPLIES:

Sort replies by

AndyPandy
Staffs, United Kingdom

Hello Blackie
67 is Hydraulic EEPROM abnormality. It is either a faulty eeprom or logic card. Reset option 3 data followed by the group 1 and 2 data with the default settings if this fails you will need a new board.

Posted 2 Dec 2008 09:50 PM

Report this message

blackie
Gelderland, Netherlands

Thanks for your reaction

We changed the boards with an other truck but than we get de code 69.
If we change them both than the other truck has the foultcode 67.

So we think your right.

If we replace the board, can we adjust it by our self or need we software or an calibrator?

Do you have any information or wiringdiagram of this truck?

Cheers

-------------------------
prajfa@hotmail.com

Posted 2 Dec 2008 09:50 PM

Report this message

AndyPandy
Staffs, United Kingdom

I have sent the information you need to the email address on you post.

Posted 2 Dec 2008 09:50 PM

Report this message

elektrodrive
West Midlands, United Kingdom

I believe the reason code 69 comes up with the board off the other truck is because of the voltage being too high? Is the card off the working truck off a lover voltage truck than the 80v system? if its the same as the EP20/25 electrics then i think you can access the parameters and make adjustments for various settings by switching the switch on the pcb to test and use the direction lever to make changes.

Posted 3 Dec 2008 09:50 PM

Report this message

blackie
Gelderland, Netherlands

Hello

Yesterday We changed the settings at menu 3 and after that we changed menu 1 and 2 .

The truck is running now.
Thanks for the help

cheers

-------------------------
prajfa@hotmail.com

Posted 11 Dec 2008 09:50 PM

Report this message

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

FORUM GLOSSARY

Click for description.

FORUM

DISCUSSION

MESSAGES

NICKNAME

SIGNATURE

FORUMS

Discuss: Industry News & Whispers

Discuss: Conferences, trade shows & other events

Discuss: Mechanical Troubleshooting

Discuss: Technical arena. Did you know? Who knows?

Discuss: Machines. Forklifts, stackers, telehandlers, container handlers and reach stackers

Discuss: Business issues

Discuss: Safety, training & legislation

Discuss: Fun at work